Preparation before configuration: 1) Power on the camera, press and hold the reset button for a few seconds, and then hear the camera voice prompts " Restore factory default settings - access point preparing - access point ready". When the (MV+ID) hotspot signal is found in the WiFi list of the mobile phone, it means that the device is in the waiting configuration state Note: The voice prompts may be different, please refer to the actual prompts of the camera : Configuration steps: 1) Click the "+" button in the upper right corner of the device list -> select [Add Camera] 2) Scan the QR code on the camera or click [Can't find the QR code on the device? Please click here]-[WiFi Smart Camera] 3) Select [AP hotspot connection] and follow the system prompts to continue operation 4) Select the WiFi that the device needs to configure, and enter the WiFi password -> click [Confirm] 5) Below Android 10: Select the device hotspot, and the mobile phone will automatically start network configuration after connecting to the hotspot Android 10 and above: Click [Connect AP spot] or enter the mobile phone system [Settings], select [WLAN], connect to the device hotspot (MV+ID), and the device will automatically connect to WiFi after returning to the app 6) The camera's voice prompts "WiFi connecting - WiFi connected" to indicate that the configuration is successful, and the APP prompts "Completed"